HARD-WIRED
ACTIVATION INSTRUCTIONS

Installing the ACT D’MAND KONTROLS® Systems

HWMSRB-W/ HWMSRB-O – Hardwired 

Converting D’MAND Kontrols® for 12 Volt Motion Sensor 

Your ACT D’MAND Kontrols® Motion sensor kit requires a 12 volt power setting adjustment on your control board. This is a simple adjustment which is done on the D’MAND Kontrols® circuit board (Figure 2). 

*Before you start, you will need a Phillips screwdriver and a knife or pair of scissors. Note, all circuit boards date stamped 5115 or later are already set to 12 V. 

Installing the ACT D’MAND KONTROLS® Systems

HWMSRB-PW – Hardwired

Connecting D’MAND Kontrols® for 12 Volt* Motion Sensor 

Your ACT D’MAND Kontrols® System is equipped to use infrared motion sensors to interface with the user(s). These sensors may be placed throughout your residence to match your needs/applications. Wiring for these systems is simple and straightforward following the guidelines below. 

Installing the ACT D’MAND KONTROLS® Systems

D’MAND (Lighted or non-lighted) Kontrols® Buttons

Applicable for HWRS-LED or HWRS

Thank you for purchasing an ACT, Inc. D’MAND ® system with the “NEW” HWRS-LED D’MAND Kontrols® Button.

This HWRS-LED D’MAND Kontrols® button is designed to light up when the ACT, Inc. D’MAND Kontrols® system is activated and stays on until the pump turns off. This allows the user to observe the pump’s operation remotely.

We are separating and marking the two Buttons, the standard non-lighted Button (HWRS) and the “NEW” LED upgrade (HWRS-LED) so you can choose your placement.

Installing the ACT D’MAND KONTROLS® Systems

Lighted D’MAND Kontrols® Buttons

HWB-CH-LED/ HWB-LED-S

Thank you for purchasing an ACT D’MAND Kontrols® System with the “NEW” Green LED

D’MAND Kontrols® Button. This Green LED D’MAND Kontrols® Button is designed to light up

when the ACT D’MAND Kontrols® System is activated and stays on until the pump turns off.

This allows the user to observe the pump’s operation remotely.